Vinyl Sticker Install Tip

Get the most out of your Do Better decals by following these simple install steps:

1. Clean the Surface (Important!)

Use a clean water-dampened rag or a mild soap and water mix to wipe down the area.
Do not use alcohol-based cleaners.
They can cause outgassing, which may lead to poor adhesion or bubbling under your sticker.

2. Position the Sticker

Before peeling, line it up exactly where you want it. If needed, use masking tape as a hinge to hold it in place.

3. Peel and Apply

Slowly peel the backing paper away, making sure the vinyl stays stuck to the clear transfer tape.

4. Press It On

Apply the sticker using firm, even pressure with a squeegee or credit card, working from the center outward to avoid bubbles.

5. Remove Transfer Tape

Carefully peel the transfer tape back at a sharp angle. If any part lifts, press it down and continue slowly.

Quick Pro Tips